Configuring the Internal Baseband Source
R&S
®
SMBV100B
159User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed on page 749
Generate Signal RAM
Generates a signal and uses it as output straight away. The instrument stores the file
with a predefined name.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate on page 749
3.6.3.5 Trigger, Marker and Clock Setting
These tabs provide standard settings.
For detailed description, see:
●
Chapter 3.4.2.1, "Trigger Settings", on page 110
●
Chapter 3.4.2.2, "Marker Settings", on page 113
●
Chapter 3.4.2.3, "Clock Settings", on page 115
●
Chapter 3.4.2.4, "Global Connector Settings", on page 115
The following settings are specific to the ARB dialog.
Marker Mode
Basic marker configuration for up to three marker channels. The contents of the dialog
change with the selected marker mode.
Use the settings to define the shape and periodicity of the markers. See Regular
Marker Output Signals for description of the regular marker signals.
Note: The marker trace in the waveform file remains unchanged in any case. It is not
overwritten, even if something else than Unchanged has been selected.
The instrument routes the generated marker signals to the selected output connectors.
See Chapter 10.2, "Configuring the Global Connectors", on page 515.
"Unchanged"
The marker signal remains unchanged as defined in the waveform
file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:MODE on page 777
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider
on page 778
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
on page 778
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern on page 777
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:OFFTime on page 777
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:ONTime on page 777
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
