Rohde & Schwarz SMBV100B - Show Powers for Output;Noise Power;Output Results Settings; Noise Power;Output Results Settings; Show Powers for Output

Adding Noise and Predistortions, and Impairing the Signal
R&S
®
SMBV100B
262User Manual 1178.4460.02 ─ 03
4.1.3.2 Noise Power/Output Results Settings
Access:
► Select "AWGN > Noise Power/Output Results".
The available settings depend on the selected Mode.
Settings:
Show Powers for Output............................................................................................. 262
Set Noise Power Via................................................................................................... 263
Reference Mode..........................................................................................................263
Bit Rate....................................................................................................................... 263
Carrier/Noise Ratio, Signal/Noise Ratio...................................................................... 263
E
b
/N
0
............................................................................................................................264
Carrier Power, Signal Power....................................................................................... 264
Noise Power (System Bandwidth), Interferer Power...................................................265
Noise Power (Total Bandwidth)...................................................................................266
Carrier + Noise Power, Signal + Noise Power (System Bandwidth), Carrier + Interferer
Power, Signal + Interferer Power ............................................................................... 266
Carrier + Noise PEP, Signal + Noise PEP (Total Bandwidth), Carrier + Interferer PEP,
Signal + Interferer PEP............................................................................................... 266
Noise Bandwidth......................................................................................................... 266
Resulting CW Frequency Offset..................................................................................266
Show Powers for Output
Sets the output to which the displayed settings are related to.
This setting also influences:
●
The way the interfering parameters are displayed, e.g. if the SNR value is defined
as C/N or as S/N.
Adding Noise to the Signal