Configuring the RF Signal
R&S
®
SMBV100B
291User Manual 1178.4460.02 ─ 03
The display is disabled when:
– List mode is running, see Chapter 6.10, "Varying the RF Signal in List or Sweep
Mode", on page 310.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed] on page 824
Offset
Sets the frequency offset.
This value represents the frequency shift of a downstream instrument, like for example
a mixer.
The "Frequency" value displayed in the status bar is the resulting frequency, as it is at
the output of the downstream instrument. The frequency at the R&S SMBV100B RF
output is not changed.
See "RF frequency and level display with a downstream instrument" on page 288.
Remote command:
[:SOURce<hw>]:FREQuency:OFFSet on page 826
Multiplier
Sets the multiplication factor for the RF frequency.
This value represents the multiplication factor of a downstream instrument, like for
example a multiplier.
The "Frequency" value displayed in the status bar is the resulting frequency, as it is at
the output of the downstream instrument. The frequency at the R&S SMBV100B RF
output is not changed.
See "RF frequency and level display with a downstream instrument" on page 288.
Remote command:
[:SOURce<hw>]:FREQuency:MULTiplier on page 826
User Variation
Defines and activates a user-defined step width for varying the RF frequency or RF
level with the rotary knob.
If disabled, the step width varies in steps of one unit at the cursor position.
Variation Active ← User Variation
Activates the set user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP:MODE on page 828
[:SOURce<hw>]:POWer:STEP:MODE on page 873
Variation Step ← User Variation
Sets the user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement] on page 828
[:SOURce<hw>]:POWer:STEP[:INCRement] on page 874
RF Frequency Settings
To Next Page
Loading...
