Configuring the RF Signal
R&S
®
SMBV100B
328User Manual 1178.4460.02 ─ 03
Note: Active sweep mode deactivates other sweeps or lists and vice versa.
Remote command:
[:SOURce<hw>]:LFOutput:FREQuency:MODE on page 841
Current Frequency
In "RF/LF Frequency Sweep" mode, displays the current frequency.
In Mode = "Step", the parameter is editable and you can enter the next frequency step.
Remote command:
[:SOURce<hw>]:FREQuency:MANual on page 825
[:SOURce<hw>]:LFOutput:FREQuency:MANual on page 841
Current Level
Applies to "RF Level Sweep" mode.
Displays the current level value.
In Mode = "Step", the parameter is editable and you can enter the next level step.
Remote command:
[:SOURce<hw>]:POWer:MANual on page 871
Mode
Selects the sweep mode.
For detailed information on the sweep modes and the triggering, see Chapter 6.10.1,
"Signal Generation and Triggering in the Sweep and List Modes", on page 312.
"Auto"
Generates a continuously repeating sweep signal directly after acti-
vating the sweep mode.
The sweep steps are performed automatically, controlled by the dwell
time.
"Single / Extern Single"
Generates a single sweep cycle after a trigger event.
The sweep steps within the cycle are performed automatically, con-
trolled by the dwell time. If one cycle is completed, the instrument
waits for the next trigger event.
"Step / Extern Step"
Generates the sweep signal step-by-step, manually triggered.
"Extern Start/Stop"
Generates a continuously repeating sweep signal that is started,
stopped, and restarted by subsequent external trigger events.
The sweep steps are performed automatically, controlled by the dwell
time.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:MODE on page 886
[:SOURce<hw>]:SWEep:POWer:MODE on page 884
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE on page 848
:TRIGger<hw>[:SWEep]:SOURce on page 922
:TRIGger<hw>:FSWeep:SOURce on page 922
:TRIGger<hw>:PSWeep:SOURce on page 922
:TRIGger<hw>:LFFSweep:SOURce on page 922
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...
