Rohde & Schwarz SMBV100B - Page 334

Configuring the RF Signal
R&S
®
SMBV100B
332User Manual 1178.4460.02 ─ 03
Settings
Start Frequency/Stop Frequency ............................................................................... 332
Center Frequency ...................................................................................................... 332
Span............................................................................................................................332
Spacing....................................................................................................................... 332
Step Linear/Step Logarithmic .....................................................................................333
Start Frequency/Stop Frequency
Defines the frequency sweep range by setting the start and end values.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode", on page 320.
Remote command:
[:SOURce<hw>]:FREQuency:STARt on page 827
[:SOURce<hw>]:FREQuency:STOP on page 828
[:SOURce<hw>]:LFOutput:FREQuency:STARt on page 841
[:SOURce<hw>]:LFOutput:FREQuency:STOP on page 841
Center Frequency
In "RF Frequency Sweep" mode, sets the RF center frequency.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode", on page 320.
Remote command:
[:SOURce<hw>]:FREQuency:CENTer on page 827
Span
In "RF Frequency Sweep" mode, sets the span of the frequency sweep range.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode", on page 320.
Remote command:
[:SOURce<hw>]:FREQuency:SPAN on page 827
Spacing
In "RF and LF Frequency Sweep" modes, selects the mode for the calculation of the
frequency intervals, with which the current frequency at each step is increased or
decreased.
Enter the step size with the parameter Step Linear/Step Logarithmic .
"Linear"
Takes the frequency value entered as absolute value in Hz.
Varying the RF Signal in List or Sweep Mode