Configuring the RF Signal
R&S
®
SMBV100B
350User Manual 1178.4460.02 ─ 03
Access:
► Select "RF" > "Analog Modulation" > "Pulse Modualtion".
The "Pulse Modulation" dialog contains all parameters required to configure pulse
modulation and pulse signal generation.
It also displays the pulse signal graphically.
For an overview of the supported signals sources and related connectors, see Chap-
ter 6.11.2, "Modulation Types and Signal Sources", on page 347.
The remote commands required to define these settings are described in Chap-
ter 12.16.3.5, "SOURce:PULM Subsystem", on page 703.
Settings:
State............................................................................................................................350
Source.........................................................................................................................350
Transition Type............................................................................................................351
Video Polarity..............................................................................................................351
State
Activates pulse modulation and triggers the following automatic settings:
●
Pulse generator is activated.
The signal is output at the Pulse Video connector.
To deactivate the signal output, set "Pulse Generator" > Pulse Output State > "Off".
Remote command:
[:SOURce<hw>]:PULM:STATe on page 707
Source
Selects between the internal "Pulse Generator" or an "External" pulse signal for the
modulation.
Analog Modulations
To Next Page
Loading...
