Configuring the RF Signal
R&S
®
SMBV100B
372User Manual 1178.4460.02 ─ 03
Remote command:
[:SOURce]:LFOutput:SIMPedance on page 843
Noise Generator
Access:
●
Select "RF" > "Analog Modulation" > "LF Output > Noise Generator".
Noise Density ← Noise Generator
Indicates the level of the noise signal for a bandwidth of 1 Hz (relative).
Remote command:
[:SOURce<hw>]:NOISe:LEVel:RELative? on page 864
Noise Level ← Noise Generator
Indicates the level of the noise signal per Hz within the total bandwidth (absolute).
Remote command:
[:SOURce<hw>]:NOISe:LEVel[:ABSolute]? on page 864
6.11.4.8 Overview
Option: AM and FM/PM require R&S SMBVB-K720
Access:
► Select "RF" > "Analog Modulation" > "Modulation Source... > Overview".
Blue color
= Active output signal (AM and FM)
Gray color = Inactive output signal (LF Out)
Miniature graph = Indicates an active source
Connectors = Indicate a connector (e.g. external signal) is involved in the path of the signal
Analog Modulations
To Next Page
Loading...
