Rohde & Schwarz SMBV100B - User Correction Settings

Configuring the RF Signal
R&S
®
SMBV100B
384User Manual 1178.4460.02 ─ 03
6.12.3.1 User Correction Settings
Access:
1. Select "RF" > "RF Level" > "User Correction".
2. If you already have created a file with user correction data:
a) Select "UCOR Data > navigate to the file *.uco > Select".
b) Proceed with step 4.
3. If you need to create a new file:
a) Select "UCOR Data > New".
b) Enter the filename UCOR_Data and confirm with "Ok".
c) Choose the file and confirm with "Select".
d) Select "Edit UCOR Data".
e) To fill the user corerction data table, proceed as described in Chapter 6.12.3,
"User Correction", on page 381.
4. Select block diagram > RF > "On".
5. Select "State > On".
The "UCOR" dialog contains all settings for creating and handling files with user-
defined level correction values.
The remote commands required to define these settings are described in Chap-
ter 12.16.5, "SOURce:CORRection Subsystem", on page 810.
Settings
State............................................................................................................................385
User Correction...........................................................................................................385
UCOR Data.................................................................................................................385
Edit UCOR Data..........................................................................................................385
Improving Level Performance