Multi-Instrument Setups
R&S
®
SMBV100B
451User Manual 1178.4460.02 ─ 03
"Scan"
Scans the network for connected supported instruments, like:
R&S SGS or R&S SGT.
Note: The scan function searches throughout the entire network and
can last several minutes.
Remote command:
:SCONfiguration:EXTernal:REMote:SCAN on page 672
:SCONfiguration:EXTernal:REMote:SCAN:STATe? on page 672
Clean Unused/Clean All
Triggers the instrument to clean at once all unused LAN connections. This function
allows you to retrieve a new pool of valid instruments.
The "Clean All" function removes all configured settings from the "External RF and
I/Q". USB connections to external instruments are not affected.
Remote command:
:SCONfiguration:EXTernal:REMote:PURGe on page 675
:SCONfiguration:EXTernal:REMote:CLEan on page 676
External Instrument
Lists all available instruments, found by the Detect/Scan function.
To connect an external instrument, use one of the following:
●
Enable "Select Instrument > New" and configure the settings manually
●
Select "Select Instrument", navigate trough the pool of available instruments, and
select the required. The required settings are retrieved and updated automatically.
Select "None" to disable the connection.
Execute "Apply" to confirm the settings.
Remote command:
:SCONfiguration:EXTernal:REMote:LIST? on page 672
:SCONfiguration:EXTernal:REMote:ADD on page 672
:SCONfiguration:EXTernal:DIGital:REMote:ISELect on page 674
:SCONfiguration:EXTernal:IQOutput:REMote:ISELect on page 674
Set Symbolic Name
Sets the alias name of the instrument.
Remote command:
:SCONfiguration:EXTernal:REMote:ADD on page 672
:SCONfiguration:EXTernal:DIGital:REMote:INFO? on page 674
:SCONfiguration:EXTernal:IQOutput:REMote:INFO? on page 674
Remote Channel
Selects the hardware channel (USB or LAN) used by the remote channel to the exter-
nal instrument.
Remote command:
:SCONfiguration:EXTernal:REMote:ADD on page 672
:SCONfiguration:EXTernal:DIGital:REMote:INFO? on page 674
:SCONfiguration:EXTernal:IQOutput:REMote:INFO? on page 674
System Configuration Settings
To Next Page
Loading...
