Multi-Instrument Setups
R&S
®
SMBV100B
458User Manual 1178.4460.02 ─ 03
Settings:
State............................................................................................................................458
Interface...................................................................................................................... 458
Sample Rate Source...................................................................................................458
Connected Device.......................................................................................................459
State
Note: This function will be supported in a future firmware version.
The "Baseband Input" cannot be activated. However, the baseband input related set-
tings in the "Baseband Input" or "System configuration > External RF and I/Q" are dis-
played and described, as are the respective remote control commands.
These settings have no effect because the baseband input interfaces cannot be activa-
ted.
Enables the feeding of the selected external digital signals into the baseband.
Note: The internal baseband generator ("Baseband" block) and the external digital
baseband input ("BB Input") cannot be activated simultaneously. They deactivate each
other.
Remote command:
[:SOURce<hw>]:BBIN:STATe on page 683
Interface
Indicates the used digital interface.
Sets which of the digital interfaces is used, the Dig I/Q or the HS Dig I/Q.
Remote command:
[:SOURce<hw>]:BBIN:DIGital:INTerface on page 683
Sample Rate Source
Indicates the digital interface used to estimate the sample rate.
Digital Baseband Input Settings
To Next Page
Loading...
