General Instrument Functions
R&S
®
SMBV100B
511User Manual 1178.4460.02 ─ 03
The remote commands required to configure the display and keyboard are described in
Chapter 12.9, "DISPlay Subsystem", on page 634 and Chapter 12.12, "KBOard Sub-
system", on page 646.
Screen Saver...............................................................................................................511
Wait Time.....................................................................................................................511
Display.........................................................................................................................511
RF Hardkey................................................................................................................. 511
USB Keyboard > Layout..............................................................................................511
Screen Saver
Activates the screensaver.
If activated, the display including backlight is switched off after the selected Wait Time
elapses and if no entries via touch panel, front panel, external mouse, or external key-
board are made
Remote command:
:DISPlay:PSAVe[:STATe] on page 636
Wait Time
Enters the idle time that must elapse before the display lamp is shut off when no
entries are made.
Remote command:
:DISPlay:PSAVe:HOLDoff on page 636
Display
Adjusts the brightness of the display.
Increase the value to turn up the display brightness.
Remote command:
:DISPlay:BRIGhtness on page 636
RF Hardkey
Adjusts the brightness of the [RF on/off] key.
Increase the value to change the contrast between the key and the front panel back-
ground color.
Remote command:
:DISPlay:BUTTon:BRIGhtness on page 636
USB Keyboard > Layout
Selects the language of an externally connected keyboard via USB. The function
assigns the corresponding keys automatically.
Remote command:
:KBOard:LAYout on page 646
Customizing the User Interface
To Next Page
Loading...
