General Instrument Functions
R&S
®
SMBV100B
546User Manual 1178.4460.02 ─ 03
A new password does not take effect until you confirm it with the corresponding
"Change Password" button.
To confirm the new password, always press:
●
"User Password" > Change Password
Or
●
"Security Password" > Change Password
User Name
Indicates the user name used for access to the Linux operating system and valid for
VNC, FTP and SMB (Samba) access.
User Password
Access: select "System Config > Setup > Security > Security > Password Management
> User Password".
Allows you to change and confirm the user password.
Old Password ← User Password
Enters the current user password. The default password is "instrument".
Note: We recommend that you change the default password before connecting the
instrument to a network.
New Password ← User Password
Enters the new user password.
The security password can contain decimal characters only.
Confirm Password ← User Password
Confirms the new user password by repeating.
Note: The new password is not assigned until you select the Change Password button.
Using the Security Settings
To Next Page
Loading...
