Remote Control Commands
R&S
®
SMBV100B
628User Manual 1178.4460.02 ─ 03
<DestinationFile> string
String parameters to specify the name of the new file.
Usage: Event
SCPI confirmed
Manual operation: See "Rename " on page 493
:MMEMory:MSIS <Msis>
Defines the drive or network resource (in the case of networks) for instruments with
windows operating system, using msis (MSIS = Mass Storage Identification String).
Note: Instruments with Linux operating system ignore this command, since Linux does
not use drive letter assignment.
Usage:
SCPI confirmed
:MMEMory:RDIRectory
<Directory>
Removes an existing directory from the mass memory storage system. If no directory
is specified, the subdirectory with the specified name is deleted in the default directory.
Setting parameters:
<Directory> string
String parameter to specify the directory to be deleted.
Usage: Event
:MMEMory:STORe:STATe <savrcl_state_nr>, <file_name>
Stores the current instrument setting in the specified file.
The instrument setting must first be stored in an internal memory with the same num-
ber using the common command *SAV.
Setting parameters:
<savrcl_state_nr> Corresponds to the specific <number> defined with the *SAV
command, e.g. *SAV 4.
<file_name> String parameter to specify the file name with extension
*.savrcltxt.
Usage: Event
Manual operation: See "Save" on page 484
:MEMory:HFRee?
Returns the used and available memory in Kb.
MMEMory Subsystem
To Next Page
Loading...
