Rohde & Schwarz SMBV100B - Page 637

Remote Control Commands
R&S
®
SMBV100B
635User Manual 1178.4460.02 ─ 03
Programming Examples
Example: Activating screen saver mode and display update
Use the following commands to switch on the screen saver of your instrument or to
automatic display. These settings are particularly useful when you control the instru-
ment remotely.
// Set the wait time interval and activate the screen saver
:DISPlay:PSAVe:HOLDoff 10
:DISPlay:PSAVe:STATe ON
// Disable the display of the current frequency and level values in remote control
:DISPlay:ANNotation:ALL ON
// :DISPlay:ANNotation:FREQuency ON
// :DISPlay:ANNotation:AMPLitude ON
// Enable automatic update of the display at defined time intervals
:DISPlay:UPDate ON
Example: Querying the dialog IDs, opening and closing dialogs
Use the following commands to query the dialog IDs of all currently open dialogs. The
dialog ID is a prerequisite for opening and closing dialogs via the remote control.
The dialog ID is also required to define user key actions.
See Chapter 10.3.3, "Assigning Actions to the [★ (User)] Key", on page 529.
// Query the dialog IDs of all open dialogs
:DISPlay:DIALog:ID?
// CEUtraDLGenSetDlg,_,$A DlgKeyRf_Rosc
// Open and close dialogs via remote control
:DISPlay:DIALog:OPEN "CEUtraDLGenSetDlg,_,$A"
:DISPlay:DIALog:OPEN "DlgKeyRf_Rosc"
:DISPlay:DIALog:CLOSe "DlgKeyRf_Rosc"
:DISPlay:DIALog:CLOSe:ALL
:DISPlay:PSAVe:HOLDoff............................................................................................... 636
:DISPlay:PSAVe[:STATe].................................................................................................636
:DISPlay:BRIGhtness..................................................................................................... 636
:DISPlay:BUTTon:BRIGhtness.........................................................................................636
:DISPlay:UPDate........................................................................................................... 637
:DISPlay:ANNotation:AMPLitude..................................................................................... 637
:DISPlay:ANNotation:FREQuency....................................................................................637
:DISPlay:ANNotation[:ALL]..............................................................................................637
:DISPlay:DIALog:ID?......................................................................................................638
:DISPlay:DIALog:OPEN..................................................................................................638
:DISPlay:DIALog:CLOSe................................................................................................ 639
:DISPlay:DIALog:CLOSe:ALL..........................................................................................639
DISPlay Subsystem