Rohde & Schwarz SMBV100B - Format Subsystem

Remote Control Commands
R&S
®
SMBV100B
639User Manual 1178.4460.02 ─ 03
Setting parameters:
<DialogId> string
To find out the dialog identifier, use the query :DISPlay:
DIALog:ID?.
The <DialogName> part of the query result is mandatory.
Example: See Example "Querying the dialog IDs, opening and closing dia-
logs" on page 635
Usage: Setting only
Manual operation: See "SCPI" on page 529
:DISPlay:DIALog:CLOSe
<DialogId>
Closes the specified dialog.
Setting parameters:
<DialogId> string
To find out the dialog identifier, use the query :DISPlay:
DIALog:ID?.
The <DialogName> part of the query result is sufficient.
Example: See Example "Querying the dialog IDs, opening and closing dia-
logs" on page 635
Usage: Setting only
:DISPlay:DIALog:CLOSe:ALL
Closes all open dialogs.
Example:
See Example "Querying the dialog IDs, opening and closing dia-
logs" on page 635
Usage: Event
12.10 FORMat Subsystem
The commands in the FORMat subsystem determine the format of data returned by the
R&S SMBV100B to the controller. This affects all query commands that return a list of
numerical data or block data, noted in the descriptions of the commands. The set data
format applies to both paths.
:FORMat:BORDer..........................................................................................................640
:FORMat:SREGister.......................................................................................................640
:FORMat[:DATA]............................................................................................................ 640
FORMat Subsystem