Rohde & Schwarz SMBV100B - Page 687

Remote Control Commands
R&S
®
SMBV100B
685User Manual 1178.4460.02 ─ 03
Parameters:
<BbinHsChPoPeak> float
Range: -60 to 3.02
Increment: 0.01
*RST: 0
Example: See Example "Applying an external digital baseband signal (HS
Dig I/Q)" on page 682.
Manual operation: See "Peak Level" on page 461
[:SOURce<hw>]:BBIN:CHANnel<ch0>:POWer:RMS
<BbinIqHsChPoRms>
Queries the estimated RMS level.
Parameters:
<BbinIqHsChPoRms> float
Range: -100 to 10
Increment: 0.01
*RST: 0
Example: See Example "Applying an external digital baseband signal (HS
Dig I/Q)" on page 682.
Manual operation: See "Level" on page 461
[:SOURce<hw>]:BBIN:CHANnel<ch0>:SRATe <BbinIqHsChSaRat>
Sets the sample rate per channel.
Parameters:
<BbinIqHsChSaRat> float
Range: 400 to 100E6
Increment: 0.001
*RST: 100E6
Example: See Example "Applying an external digital baseband signal (HS
Dig I/Q)" on page 682.
Manual operation: See "Sample Rate" on page 461
[:SOURce<hw>]:BBIN:SRATe:SUM?
[:SOURce<hw>]:BBIN:SRATe:MAX?
Queries the maximum sample rate.
Return values:
<DigIqHsOutSRMax> integer
Range: 1050E6 to 1250E6
*RST: 1050E6
Example: See Example "Applying an external digital baseband signal (HS
Dig I/Q)" on page 682.
SOURce Subsystem