Remote Control Commands
R&S
®
SMBV100B
757User Manual 1178.4460.02 ─ 03
Manual operation: See "Save List/Save List As..." on page 201
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad <FilenameInput>
Creates a multi-segment waveform using the current entries of the specified configura-
tion file (*.inf_mswv).
The ARB generator is activated, the new multi-segment waveform (*.wv) is loaded
and the first segment is output in accordance to the trigger settings.
Setting parameters:
<FilenameInput> string
Absolute file path, file name of the configuration file and file
extension (*.inf_mswv)
Example: See Example "Creating a multi-segment waveform" on page 740
Usage: Setting only
Manual operation: See "Save List/Save List As..." on page 201
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:MODE <Mode>
Defines the way the marker information within the separate segments is processed.
Parameters:
<Mode> IGNore | TAKE
*RST: TAKE
Example: see Example "Adding extra marker signals" on page 743
Manual operation: See "Segment Marker" on page 206
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
<Mode>
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
<Mode>
Enables/disables the generation of an additional marker restart signal at the beginning
of the first segment (FSEGment) or at the beginning of each segment (ESEGment).
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
Parameters:
<Mode> OFF | MRK1 | MRK2 | MRK3 | MRK4
*RST: OFF
Example: see Example "Adding extra marker signals" on page 743
Manual operation: See "Sequence Restart" on page 206
SOURce Subsystem
To Next Page
Loading...
