Remote Control Commands
R&S
®
SMBV100B
785User Manual 1178.4460.02 ─ 03
Parameters:
<Spacing> float
Value range depends on the available bandwidth and the num-
ber of carriers, see "Cross-reference between total bandwidth,
carrier spacing, and number of carriers" on page 243.
Range: 0 to depends on the installed options, e.g. 120E6
Increment: 0.01
*RST: 10E3
Example: See "Programming Examples" on page 779
Manual operation: See "Carrier Spacing" on page 243
[:SOURce<hw>]:BB:MCCW:CLOCk?
Queries the output clock rate. The output clock rate depends on the number of carriers
and on the selected carrier spacing.
Return values:
<Clock> float
Range: 0 to Max
Increment: 1E-3
*RST: 0
Example: See "Programming Examples" on page 779
Usage: Query only
Manual operation: See "Clock Frequency" on page 243
[:SOURce<hw>]:BB:MCCW:CFACtor:MODE <Mode>
Sets the mode by which automatic settings minimize the crest factor or hold it at a
chosen value.
Parameters:
<Mode> OFF | CHIRp | SLOW
SLOW
corresponds to the manual control "Target Crest"
*RST: CHIRp
Example: See "Programming Examples" on page 779
Manual operation: See "Optimize Crest Factor Mode" on page 243
[:SOURce<hw>]:BB:MCCW:CFACtor <CFactor>
Sets the desired crest factor, if the optimization mode target crest factor is used.
SOURce Subsystem
To Next Page
Loading...
