Rohde & Schwarz SMBV100B - Page 805

Remote Control Commands
R&S
®
SMBV100B
803User Manual 1178.4460.02 ─ 03
Suffixes
The following suffixes are used:
Suffix Value range Description
RF<ch>,
IQOutput<ch>
1 IQ connector
Required options
See Chapter 4.2.1, "Required Options", on page 269.
[:SOURce]:BB:IMPairment:IQOutput<ch>:DELay.............................................................. 803
[:SOURce]:BB:IMPairment:RF<ch>:DELay.......................................................................803
[:SOURce<hw>]:IQ:IMPairment:IQRatio[:MAGNitude]........................................................804
[:SOURce]:BB:IMPairment:IQOutput<ch>:IQRatio[:MAGNitude]..........................................804
[:SOURce]:BB:IMPairment:RF<ch>:IQRatio[:MAGNitude].................................................. 804
[:SOURce<hw>]:IQ:IMPairment:LEAKage:I.......................................................................804
[:SOURce<hw>]:IQ:IMPairment:LEAKage:Q..................................................................... 804
[:SOURce]:BB:IMPairment:IQOutput<ch>:LEAKage:I........................................................ 804
[:SOURce]:BB:IMPairment:IQOutput<ch>:LEAKage:Q.......................................................804
[:SOURce]:BB:IMPairment:RF<ch>:LEAKage:I................................................................. 804
[:SOURce]:BB:IMPairment:RF<ch>:LEAKage:Q................................................................804
[:SOURce<hw>]:IQ:IMPairment:QUADrature[:ANGLe].......................................................805
[:SOURce]:BB:IMPairment:IQOutput<ch>:QUADrature[:ANGLe].........................................805
[:SOURce]:BB:IMPairment:RF<ch>:QUADrature[:ANGLe]..................................................805
[:SOURce]:BB:IMPairment:IQOutput<ch>:SKEW.............................................................. 805
[:SOURce]:BB:IMPairment:RF<ch>:SKEW....................................................................... 805
[:SOURce<hw>]:IQ:IMPairment[:STATe]........................................................................... 806
[:SOURce]:BB:IMPairment:IQOutput<ch>:STATe...............................................................806
[:SOURce]:BB:IMPairment:RF<ch>:STATe........................................................................806
[:SOURce]:BB:IMPairment:IQOutput<ch>:POFFset...........................................................806
[:SOURce]:BB:IMPairment:RF<ch>:POFFset....................................................................806
[:SOURce<hw>]:BB:IMPairment:OPTimization:MODE....................................................... 806
[:SOURce]:BB:IMPairment:IQOutput<ch>:DELay <Delay>
[:SOURce]:BB:IMPairment:RF<ch>:DELay <Delay>
Defines the time delay of both I and Q vectors between the marker signal at the marker
outputs relative to the signal generation start.
A positive value means that the I and Q vectors delay relative to the marker/trigger and
vice versa.
Table 12-2: Value range
Output Min Max Resolution
RF<ch>
0 10E-6 1E-12
IQOutput<ch>
-500E-9 500E-9 1E-12
BBMM<ch>
-500E-9 500E-9 1E-12
SOURce Subsystem