Rohde & Schwarz SMBV100B - Page 885

Remote Control Commands
R&S
®
SMBV100B
883User Manual 1178.4460.02 ─ 03
SOURce1:SWEep:FREQuency:DWELl 500 ms
// With logarithmic spacing select the step width as follows
// (steps of 10 percent of the previous frequency in each instance)
SOURce1:SWEep:FREQuency:SPACing LOG
SOURce1:SWEep:FREQuency:STEP:LOGarithmic 10PCT
// Activate the sweep
// Trigger the sweep (depending on the set mode) and query the status
SOURce1:FREQuency:MODE SWEep
// Perform a one-off RF frequency sweep
SOURce1:SWEep:FREQuency:EXECute
SOURce1:SWEep:FREQuency:RUNNing?
// 1
// the frequency sweep is running
// For manual step RF sweep use the following commands
*RST; *CLS
// Activate manual step RF sweep
SOURce1:SWEep:FREQuency:MODE MANual
// Activate the RF frequency sweep.
SOURce1:FREQuency:MODE SWEep
// Activate RF Output1.
Output1:STATe 1
// Input the frequency manually for each step
SOURce1:FREQuency:MANual 200 MHz
SOURce1:FREQuency:MANual 201 MHz
// Alternatively use the UP or DOWN commands with the set step width.
SOURce1:SWEep:FREQuency:STEP:LINear 1 MHz
SOURce1:FREQuency:MANual UP
[:SOURce<hw>]:SWEep:POWer:DWELl...........................................................................884
[:SOURce<hw>]:SWEep:POWer:MODE...........................................................................884
[:SOURce<hw>]:SWEep:POWer:POINts.......................................................................... 884
[:SOURce<hw>]:SWEep:POWer:SPACing:MODE?........................................................... 885
[:SOURce<hw>]:SWEep:POWer:STEP[:LOGarithmic]....................................................... 885
[:SOURce<hw>]:SWEep[:FREQuency]:DWELl..................................................................885
[:SOURce<hw>]:SWEep[:FREQuency]:MODE..................................................................886
[:SOURce<hw>]:SWEep[:FREQuency]:POINts................................................................. 886
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing...............................................................886
[:SOURce<hw>]:SWEep:POWer:SHAPe..........................................................................887
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe................................................................. 887
[:SOURce<hw>]:SWEep:POWer:EXECute....................................................................... 887
[:SOURce<hw>]:SWEep[:FREQuency]:EXECute.............................................................. 887
[:SOURce<hw>]:SWEep:POWer:RETRace.......................................................................887
[:SOURce<hw>]:SWEep[:FREQuency]:RETRace..............................................................887
[:SOURce<hw>]:SWEep:POWer:RUNNing?..................................................................... 888
[:SOURce<hw>]:SWEep[:FREQuency]:RUNNing?............................................................ 888
[:SOURce<hw>]:SWEep[:FREQuency]:STEP:LOGarithmic................................................ 888
[:SOURce<hw>]:SWEep[:FREQuency]:STEP[:LINear].......................................................888
[:SOURce<hw>]:SWEep:RESet[:ALL].............................................................................. 889
SOURce Subsystem