Remote Control Commands
R&S
®
SMBV100B
925User Manual 1178.4460.02 ─ 03
:UNIT:ANGLe.................................................................................................................925
:UNIT:POWer.................................................................................................................925
:UNIT:VELocity.............................................................................................................. 925
:UNIT:ANGLe <Angle>
Sets the default unit for phase modulation angle. The command affects no other
parameters, such as RF phase, or the manual control or display.
Parameters:
<Angle> DEGree | DEGRee | RADian
*RST: RADian
:UNIT:POWer
<Power>
Sets the default unit for all power parameters. This setting affects the GUI, as well as
all remote control commands that determine power values.
Parameters:
<Power> V | DBUV | DBM
*RST: DBM
:UNIT:VELocity <Velocity>
Sets the default unit for the velocity of the wave.
Parameters:
<Velocity> MPS | KMH | MPH | NMPH
*RST: MPS
UNIT Subsystem
To Next Page
Loading...
