Command Description R&S SMC100A
1411.4060.32 6.68 E-1
[SOURce:]PULM:DELay 20ns .. 1s
The command sets the pulse delay. The pulse delay determines the time that elapses after a trigger
event before pulse modulation starts. The pulse delay is not effective for double pulse generation.
Example:
PULM:DEL 13 us
'13 us elapse after a trigger before the first pulse is generated.
*RST value Resolution Options SCPI
20 ns 20 ns Device-specific
[SOURce:]PULM:DOUBle:DELay 20ns .. 1s
The command sets the delay from the start of the first pulse to the start of the second pulse.
Example:
PULM:DOUB:DEL 22 us
'22 us elapse between the beginning of the first pulse and the beginning of the
second pulse in double-pulse mode.
*RST value Resolution Options SCPI
1 ms 20 ns Device-specific
[SOURce:]PULM:DOUBle:STATe ON | OFF
The command enables/disables double pulse generation. The two pulses are generated in one pulse
period.
Example:
PULM:DOUB:STAT ON
'double-pulse mode is enabled.
*RST value Resolution Options SCPI
OFF Device-specific
[SOURce:]PULM:DOUBle:WIDTh 20ns .. 1s
The command sets the width of the second pulse in case of double pulse generation.
Example:
PULM:DOUB:WIDT 33 us
'sets a width of 33 us for the second pulse.
*RST value Resolution Options SCPI
1ms 20 ns Device-specific
To Next Page
Loading...
