Rohde & Schwarz SMC100A - Page 278

Command Description R&S SMC100A
1411.4060.32 6.76 E-1
[SOURce:]SWEep[:FREQuency]:MODE AUTO | MANual | STEP
The command sets the sweep mode.
The keyword [:FREQuency] can be omitted (see example). The command is then SCPI-compliant.
Parameters: AUTO
Each trigger triggers exactly one complete sweep.
MANual
The
trigger system is not active. Each frequency step of the sweep is triggered
individually, either by varying the Current Frequency value using the rotary
knob under manual control or by means of a FREQ:MAN command under
remote control. With manual control, the frequency increases or decreases
(depending on the direction of the rotary encoder) by the value specified under
SOUR:SWE:FREQ:STEP:LIN (linear spacing) or ...:STEP:LOG
(logarithmic
spacing). With remote control, the frequency increases by the value specified
under SWEep:FREQ:STEP:LIN|LOG which each sent :FREQ:MAN
command, irrespective the value entered there.
STEP
Each external trigger triggers one sweep step only (Mode Extern Step). The
frequency increases by the value entered under SOUR:SWE:FREQ:STEP:LIN
(linear spacing) or ...:STEP:LOG (logarithmic spacing).
Example:
SWE:MODE AUTO
'selects auto mode for a frequency sweep.
*RST value Resolution Options SCPI
AUTO - Device-specific