Rohde & Schwarz SMC100A - Status Subsystem

R&S SMC100A Command Description
1411.4060.32 6.83 E-1
STATus Subsystem
This system contains the commands for the status reporting system. *RST has no effect on the status
registers.
Queries return the current value of the respective register, which permits a check of the device status. A
decimal value between 0 and 32767 (=2
1
5
-1) is returned.
The configuration commands set the respective register thus determining which status changes of the
R&S Signal Generator causes the status registers to be changed. A decimal value between 0 and
32767 (=
2^15-1) is set.
Command Parameters Default
unit
Remark
STATus:OPERation:CONDition? Query only
STATus:OPERation:ENABle 0...32767
STATus:OPERation[:EVENt]? Query only
STATus:OPERation:NTRansition 0...32767
STATus:OPERation:PTRansition 0...32767
STATus:PRESet No query
STATus:QUEStionable:CONDition? Query only
STATus:QUEStionable:ENABle 0...32767
STATus:QUEStionable[:EVENt]? Query only
STATus:QUEStionable:NTRansition 0...32767
STATus:QUEStionable:PTRansition 0...32767
STATus:QUEue[:NEXT]? Query only
STATus:OPERation:EVENt?
The command queries the content of the EVENt part of the STATus:OPERation register. This part
contains information on the actions performed in the instrument since the last readout. The content
of the EVENt part is deleted after being read out.
Example:
STAT:OPER:EVEN?
'queries the STATus:OPERation:EVENt register.
*RST value Resolution Options SCPI
- - Compliant