R&S SMC100A Command Description
1411.4060.32 6.97 E-1
SYSTem:PROTect<n>[:STATe] ON | OFF, password
The command activates and deactivates the specified protection level. There are several protection
levels which disable specific service functions (authorized personnel of R&S Service Departments
only). These levels are identified by the suffix under PROTect.
The respective functions are disabled when the protection level is activated. No password is required
for activation. A password must be entered to deactivate the protection level. The password for the
first level is 123456. This protection level can be used to lock-out internal adjustments.
The command triggers an event and therefore has no *RST value and no query form.
Example:
SYST:PROT1 ON
'activates protection level 1. Internal adjustments are only possible after
deactivating the lock-out.
SYST:PROT1 OFF, 123456
'deactivates protection level 1. Internal adjustments are enabled again.
*RST value Resolution Options SCPI
- - Compliant
SYSTem:SERRor?
This command returns a list of all errors existing at the time when the query is started. This list
corresponds to the display on the info page under manual control.
The command is a query command and therefore has no *RST value.
Example:
"SYST:SERR?"
'queries all errors existing in the error queue.
Response:
"-221, 'Settings conflict', 153, 'Input voltage out of
range'"
'the two returned errors have occurred since the error queue was last queried.
*RST value Resolution Options SCPI
- - Device-specific
SYSTem:STARtup:COMPlete?
The command queries if the startup of the instrument is completed.
This command is a query and therefore has no *RST value.
Example:
SYST:STAR:COMP?
Response: 1
'the startup of the instrument is completed.
*RST value Resolution Options SCPI
-
To Next Page
Loading...
