Instrument Function
R&S
®
SMC100A
87Operating Manual 1411.4060.32 ─ 09
2. In the "Setup > System > NRP-Z Info Update" dialog, select "Rescue" in the left
sensor selection field
3. Activate "Run Update".
4. Confirm query in message box
5. Connect sensor within 4 seconds
The update starts, a bar informs about the progress.
Current Sensors
Shows the sensors that are connected to the generator with information on serial num-
ber, the revision state and some features.
Tip: Click on a sensor to get quick information about the firmware version and whether
this sensor measures the peak of the signal.
Remote command:
SENSe<ch>[:POWer]:TYPE? on page 276
SENSe<ch>[:POWer]:SVERsion? on page 276
SENSe<ch>[:POWer]:SNUMber? on page 275
Update
Section "Update" provides access to the file system in order to select a file for an R&S
NRP sensor update (Button "Select NRP File"), the selected file is indicated to the left
of the button. On the left side, the sensor to be updated is selected.
Button "Run Update" starts the update.
Note: If the update is interrupted for example by accidental removal of the sensor dur-
ing the process, the button "Rescue" appears. Thus, you can restart the update proc-
ess.
Prerequisite is that no other sensor is connected to the instrument.
Refer to "How to update an R&S NRP sensor" on page 86 and "How to restart an inter-
rupted update of an R&S NRP sensor" on page 86 for detailed instructions.
Remote command:
n.a.
5.2.3.6 Display Update
The "Start/Stop Display Update" dialog provides the possibility to switch off update of
the displayed parameters in order to increase speed for certain settings.
The indicated values are not updated and may therefore differ from the intern, used
values.
General Instrument Settings
To Next Page
Loading...
