Rohde & Schwarz SMC100A - Check Front Panel

Instrument Function
R&S
®
SMC100A
89Operating Manual 1411.4060.32 ─ 09
5.2.3.8 Check Front Panel
With the functions provided in this dialog you can verify the functionality of the control
keys of the R&S SMC.
In case of malfunctions, contact your Rohde & Schwarz Customer Support Center for
technical support, see http://www.customersupport@rohde-schwarz.com.
Accessing the online help in the check front panel dialog or exiting via ESC
During the test, the actual functions of all keys are disabled, including the HELP and
the ESC keys.
Check Front Panel Settings
► To access this dialog, Press the "setup" key and select "Setup > Test > Check
Front Panel".
Reflecting the front panel, the "Check Front Panel" dialog contains all functions to
test the operating elements of the instrument.
Performing the Front Panel Tests
To perform the front panel test, you operate the keys at the front panel, and check the
response of the instrument in the "Check Front Panel" dialog. To perform this test
properly, it is essential that you check each key of the front panel. The test is only com-
pleted, when you have veryfied all keys.
During the test, the actual functions of the keys are disabled.
Proceed as follows:
1. Press the SETUP key.
2. Select "Test > Check Front Panel"
The "Check Front Panel" dialog opens.
3. Press a key on the front panel.
Check if the corresponding key in the "Check Front Panel" dialog turns green.
4. Press the same key a second time.
General Instrument Settings