Rohde & Schwarz SMC100A - Phase; Phase Settings

Instrument Function
R&S
®
SMC100A
125Operating Manual 1411.4060.32 ─ 09
Remote command:
[:SOURce<hw>]:FREQuency:STEP:MODE on page 297
Variation Step
Sets the user-defined step width. This step width is used when entering the RF fre-
quency using the rotary knob. Frequency variation with this step width must also be
activated with "Variation Active".
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement] on page 297
5.3.3 Phase
The phase of the RF output signal can be changed in the "Phase Settings" section of
the "RF Frequency/Phase" dialog.
5.3.3.1 Phase Settings
► To access the dialog for configuring the phase settings, perform one of the follow-
ing:
● Select "RF > config... > RF Frequency > Frequency/Phase".
● Press the MENU key and select "RF > RF Frequency > Frequency/Phase".
The combined "RF Frequency / Phase ..." settings dialog contains the parameters
to configure the phase settings of the RF signal.
The remote commands required to define the settings are described in Chapter 7.13.9,
"SOURce:PHASe Subsystem", on page 309.
Delta Phase
Sets the phase of the RF signal. The current phase of the signal is used as the refer-
ence. This function allows, for example, the phase of the output signal to be synchron-
ized with the phase of a signal from a second signal generator.
Remote command:
[:SOURce<hw>]:PHASe on page 309
Reset Delta Phase Display
Resets delta phase value. The set phase is adopted as the new current phase, i.e. the
delta phase value is reset to 0.
Remote command:
[:SOURce<hw>]:PHASe:REFerence on page 309
RF Block