Remote Control Basics
R&S
®
SMC100A
207Operating Manual 1411.4060.32 ─ 09
After the first remote-control command has been sent, the instrument is in the
"REMOTE" state, i.e. instrument control from the front panel or via mouse and key-
board is disabled and "REMOTE" is displayed in the status line.
Telnet program examples
The following program example shows a simple TcpClient class that is intended to
explain on how to get started with programming of sockets.
The example sets up a socket communication to R&S SMC and opens a simple user
interface, very similar to the telnet, which allows input of commands. To enable real
automation, further development of the program is required.
TcpClient.h
#include <string>
//defines structs for socket handling
#include <netinet/in.h>
using namespace std;
Starting a Remote Control Session
To Next Page
Loading...
