Remote Control Commands
R&S
®
SMC100A
246Operating Manual 1411.4060.32 ─ 09
Parameters:
<HoldoffTimeMin> integer
Range: 1 to 60
*RST: 10
Default unit: minute
Example:
DISP:PSAV:HOLD 8
Sets the timeout of the screen saver to 8 minutes.
Manual operation: See "Wait Time" on page 94
:DISPlay:PSAVe[:STATe]
<State>
Activates the screen-save mode of the display.
If activated, the display including backlight is switched off after the wait time elapses
and if no entries via front panel, external mouse or external keyboard are made. To set
the wait time, use command :DISPlay:PSAVe:HOLDoff.
This mode is recommended for protecting the display, especially if you operate the
instrument via remote control.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
DISP:PSAV ON
Activates screen saver mode.
Manual operation: See "Screen Saver Active" on page 94
:DISPlay:UPDate <Update>
Activates the refresh mode of the display.
Parameters:
<Update> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:UPD ON
Activates automatic update of the display at defined time inter-
vals.
7.7 FORMat Subsystem
The FORMat subsystem contains the commands which determine the format of the
data that the R&S SMC returns to the controller. This affects all query commands
which return a list of numerical data or block data. Reference is made to this in the
descriptions of the commands.
FORMat Subsystem
To Next Page
Loading...
