Rohde & Schwarz SMC100A - Source:modulation Subsystem; Source:pgen Subsystem

Remote Control Commands
R&S
®
SMC100A
308Operating Manual 1411.4060.32 ─ 09
Example:
LFO:VOLT 2 V
sets the voltage of the LF output to 2 V.
Manual operation: See " LF Output Voltage " on page 180
7.13.7 SOURce:MODulation Subsystem
This subsystem contains the command for switching on/off all modulations.
[:SOURce<hw>]:MODulation[:ALL][:STATe] <State>
Activates/deactivates the modulations.
The command SOUR:MOD:ALL:STAT OFF switches all modulations off. A subsequent
command SOUR:MOD:ALL:STAT ON restores the status that was active before the
last switch-off. "MOD OFF" is displayed in the info line of the header next to the "Level"
field.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
MOD:STAT OFF
switches off all modulations.
Manual operation: See "MOD ON/OFF" on page 170
7.13.8 SOURce:PGEN Subsystem
This subsystem contains the commands for setting the pulse generator.
[:SOURce<hw>]:PGENerator:STATe............................................................................... 308
[:SOURce<hw>]:PGENerator:STATe <State>
Activates/deactivates the output of the video/sync signal at the PULSE VIDEO connec-
tor at the rear of the instrument.
The signal output and the pulse generator are automatically switched on with activation
of pulse modulation if pulse generator is selected as modulation source. The signal
output can be switched off subsequently.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
SOURce Subsystem