Manual Operation
R&S
®
SMC100A
69Operating Manual 1411.4060.32 ─ 09
Restoring values that require confirmation
All settings that are not confirmed with the "Accept" button but require this additional
confirmation can be restored.
1. Press the ESC key.
A confirmation query is displayed.
2. Confirm with "OK" to abort the changes.
Select "Cancel" to return to the dialog. The previous selected settings are dis-
played.
Restoring values after an extended calculation has been started
Calculation and setting might require different period of time. Many settings are made
without noticeable calculation times; such operations are indicated by a "BUSY" mes-
sage displayed in the status field of the header section.
A window with a progress indicates that the instrument performs an extended calcula-
tion that requires longer calculation time. The termination of such a calculation restores
the previous values.
► Press the ABORT button to terminate the calculation.
All previous values are restored.
4.5 Editors
The R&S SMC provides a user-friendly editor for defining frequency and level value
pairs, that are used for user-defined level correction (UCOR). The data is edited in a
list editor, as described in Working with List Editor .
The lists are saved to files and may thus have any length. The file name of the lists and
the directory to which the files are saved are user-selectable. The file prefix is different
for each list type and is permanently assigned by the system.
For information about file handling and overview of the automatically assigned file pre-
fixes, refer to Chapter 4.7, "File Management", on page 72.
4.5.1 Working with List Editor
The "List Editor" contains a table for entering user-defined frequency and level value
pairs. You can access the editor from the "User Correction" dialog. User correction is
used to increase the level accuracy of the RF output signal by means of user-defined
level correction values.
Editors
To Next Page
Loading...
