SME Sweep
1038.6002.02 2.139 E-13
DWELL
Input value of the dwell time per step.
IEC bus short command :SOUR:SWE:DWEL 10ms
SPACING
Input value of the dwell time per step.
IEC bus short command :SOUR:SWE:SPAC LIN
MODE
Selection of the sweep operating mode (cf. Section 2.8.3)..
IEC bus short commands :SOUR:FREQ:MODE SWE; :SWE:MODE AUTO;
:TRIG:SOUR SING
EXECUTE SINGLE
SWEEP
➤
Starts a single sweep run. This action to be executed is only indicated and is
only effective if MODE SINGLE has been selected.
IEC bus short command :TRIG
RESET SWEEP
➤
Sets the starting frequency.
IEC bus short command :ABOR
MARKER 1 FREQ
MARKER 2 FREQ
MARKER 3 FREQ
Input value of the frequency for the marker selected
IEC bus short command :MARK1:FREQ 100MHz
MARKER 1 STATE
MARKER 2 STATE
MARKER 3 STATE
Switching on/off the marker selected
IEC bus short command :SOUR:MARK1 OFF
AMPLITUDE MARKER1
AMPLITUDE MARKER 2
AMPLITUDE MARKER 3
Switching on/off the amplitude marker selected
OFF Input value of the frequency for the marker selected
ON Amplitude marker is switched on. On reaching the mark the output
level is reduced by 1 dB.
IEC bus short command :SOUR:MARK1:AMPL OFF
To Next Page
Loading...
