SME Sweep
1038.6002.02 2.141 E-13
EXECUTE SINGLE SWEEP Ð
Starts a single sweep run. This action to be executed is only
indicated and is only effective if MODE SINGLE is selected.
IEC bus short command :TRIG
RESET SWEEP Ð
Sets the starting level.
IEC bus short command :ABOR
MARKER 1 LEVEL
MARKER 2 LEVEL
MARKER 3 LEVEL
Input value of the level for the marker selected.
IEC bus short command :SOUR:MARK1:PSW:POW 0dBm
MARKER 1 STATE
MARKER 2 STATE
MARKER 3 STATE
Switching on/off the marker selected.
IEC bus short command :SOUR:MARK1:PSW OFF
2.8.8 LF-Sweep
Menu SWEEP - LF GEN offers access to settings for LF sweep.
Note: Settings LF SWEEP and SOURCE LFGEN2 SHAPE NOI deactivate one another.
Menu selection: SWEEP - LF GEN2
FREQUENCY
LEVEL
MODULATION
DIGITAL MOD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
HELP
FREQ
LEVEL
LFGEN
START FREQ
100.000 0
kHz
STOP FREQ
50.000 0
kHz
LEVEL dBm
START FREQ
100.000 0 kHz
STOP FREQ 50.000 0 kHz
CURRENT FREQ 82.000 0 kHz
SPACING LIN LOG
STEP LIN 1.000 0 kHz
DWELL 15.0 ms
MODE OFF AUTO SINGLE STEP EXT-INGLE EXT-STEP
EXECUTE SINGLE SWEEP
RESET SWEEP
MARKER 1 FREQ 1.000 0 kHz
MARKER 1 STATE OFF ON
MARKER 2 FREQ 2.000 0 kHz
MARKER 2 STATE OFF ON
MARKER 3 FREQ 3.000 0 kHz
MARKER 3 STATE OFF ON
- 30.0
LF2-SWP
Fig. 2-57 Menu SWEEP - LF GEN
To Next Page
Loading...
