Rohde & Schwarz SME02 - Voltage Indication of Test Points (DIAG-TPOINT)

SME Utilities
1038.6002.02 2.163 E-13
2.11.10 Voltage Indication of Test Points (DIAG-TPOINT)
Submenu DIAG-TPOINT offers access to internal test points. If a test point is switched on, the voltage
indication is displayed in a window in the header field. For greater detail, see service manual (stock no.
1039.1856.24).
Menu selection: UTILITIES - DIAG - TPOINT
FREQUENCY
LEVEL
MODULATION
DIGITAL MOD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
HELP
SYSTEM
REF OSC
PHASE
PROTECT
CALIB
DIAG
TEST
MOD KEY
AUX I/O
BEEPER
INSTALL
CONFIG
TPOINT
PARAM
FREQ
100. 000 000 0
MHz
OFF ON
7
STATE
POINT
LEVEL
-30.0
dBm
TP 007
+3.570V
Fig. 2-74 Menu UTILITIES - DIAG - TPOINT
STATE
Switching on/off the voltage indication in the headerfield.
POINT...........
Input value of the test point.
IEC-bus short command :DIAG:POINxx?