SME CALibration
1038.6002.02 3.19 E-13
:CALibration:LEVel
This node provides the commands for the management of the level correction table. The
corresponding data are permanently stored in the instrument and cannot be changed. The
instrument includes different level correction tables. The tables to be used are selected
depending on the set frequency and the pulse modulator switched on (internal or external). The
:FRANge and :PMODulator commands select the level correction tables to be read out using
the DATA? command. These commands simulate the current instrument status but do not have
any influence on the instrument setup. The :STATe ON command activates the level correction
table corresponding to the real instrument setup.
:CALibration:LEVel:DATA?
The command queries the level correction data. It returns all level correction data in the format
fixed in the :FORMat system. The other commands under this node determine the list that is
returned.
Example: :CAL:LEV:DATA?
:CALibration:LEVel:FRANge NORMal | MIXer
The command selects the level correction table valid for a frequency in the NORMal or in the
MIXer range.
Example: :CAL:LEV:FRAN NORM *RST value is NORMal
:CALibration:LEVel:PMODulator ON | OFF
The command selects the level correction table valid for an instrument setup with the pulse
modulator ON or OFF.
Example: :CAL:LEV:PMOD OFF *RST value is OFF
:CALibration:LEVel:STATe ON | OFF
The command switches on or off internal level correction. *RST value is ON.
Example: :CAL:LEV:STAT OFF
:CALibration:LPReset
The commands to measure the values for the level presetting table are under this node (Level
PReset).
:CALibration:LPReset[:MEASure]?
The command triggers a calibration measurement. The command triggers an event and thus has
no *RST value.
Example: :CAL:LPR:MEAS? Response: 0
:CALibration:LPReset:DATA?
The command queries the correction data. It returns all correction data in the format fixed in the
:FORMat system.
Example: :CAL:LPR:DATA?
To Next Page
Loading...
