SME DIAGnostic
1038.6002.02 3.23 E-13
:DIAGnostic:XMEM:CHECksum[:TOTal]?
This command queries the overall checksum for the memory extension. Beforehand, the
checksum has to be calculated using :CALCulate.
Example: :DIAG:XMEM:CHEC? Response: 178034
:DIAGnostic:XMEM:CHECksum:DATA?
This command queries the overall checksum for the DATA section of the memory extension data.
In the 8M*1 mode, this checksum is identical with the overall checksum. Beforehand, the
checksum has to be calculated using :CALCulate.
Example: :DIAG:XMEM:CHEC:DATA? Response: 10043
:DIAGnostic:XMEM:CHECksum:ATTenuate?
This command queries the overall checksum for the ATTenuate section of the memory extension
data. In the 8M*1 mode, this checksum is 0. Beforehand, the checksum has to be calculated
using :CALCulate.
Example: :DIAG:XMEM:CHEC:ATT? Response: 97134
:DIAGnostic:XMEM:CHECksum:BURSt?
This command queries the overall checksum for the BURSt section of the memory extension
data. In the 8M*1 mode, this checksum is 0. Beforehand, the checksum has to be calculated
using :CALCulate.
Example: :DIAG:XMEM:CHEC:BURS? Response: 28601
To Next Page
Loading...
