Rohde & Schwarz SME02 - Source:correction Subsystem

SOURce:CORRection SME
1038.6002.02 3.32 E-13
3.6.11.2 SOURce:CORRection Subsystem
The CORRection subsystem permits a correction of the output level. The correction is effected by
adding user-defined table values to the output level as a function of the RF frequency. In the SME, this
subsystem serves to select, transmit and switch on USER-CORRECTION tables (see Chapter 2,
Section "User Correction (UCOR)" as well).
Command Parameter Default
Unit
Remark
[:SOURce]
:CORRection
[:STATe]
:CSET
:CATalog?
[:SELect]
:DATA
:FREQuency
:POWer
:DELete
ON | OFF
"Name of table"
5 kHz to 1.5 GHz {,5 kHz to 1.5 GHz}
-40 dBto 6dB {,-40 dBto 6dB}
"Name of table"
Hz
dB
Query only
SME03E: to 2.2 GHz
SME03: to 3 GHz
SME06: to 6 GHz
[:SOURce]:CORRection[:STATe] ON | OFF
The command switches the table selected using SOURce:CORRection:CSET on or off.
Example: :SOUR:CORR:STAT ON *RST value is OFF
[:SOURce]:CORRection:CSET
The commands to select and edit the UCOR tables are under this node.
[:SOURce]:CORRection:CSET:CATalog?ß
The command requests a list of UCOR tables. The individual lists are separated by means of
commas. This command is a query and has no *RST value.
Example: :SOUR:CORR:CAT? Answer: "UCOR1", "UCOR2", "UCOR3"
[:SOURce]:CORRection:CSET[:SELect] "Name of table"
The command selects a UCOR table. This command alone does not yet effect a correction. First
the table selected must be activated (cf. :SOURce:CORRection:STATe). If there is no table of
this name, a new table is created. The name may contain up to 7 letters. This command triggers
an event and hence has no *RST value.
Example: :SOUR:CORR:CSET:SEL "UCOR1"