EasyManua.ls Logo

Rohde & Schwarz SME02 - Page 268

Rohde & Schwarz SME02
462 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SOURce:ERMes SME
1038.6002.02 3.52 E-13
[:SOURce]:ERMes:MESSage:IA | IADDress 0 to 262143
The command determines the address ("Inital ADD
ress") of the pager addressed. Each pager has
an own, nonrecurring address. 0 are 262143 are valid values, i.e. all numbers which can be
indicated using 18 bits. *RST value is 0
Example: :SOUR:ERM:MESS:IA 0
[:SOURce]:ERMes:MESSage:CATegory ALPHanumeric | NUMeric | TONE
The command specifies the category of the message to be sent.
ALPHanumeric Alphanumeric message
NUMeric Numeric message
TONETone-only message
Example: :SOUR:ERM:MESS:CAT NUM *RST value is TONE
[:SOURce]:ERMes:MESSage:ALPHanumeric
The commands to specify the contents of the alphanumeric message are under this node. These
commands are only effective if ERMes:MESSage:CATegory ALPHanumeric is selected.
[:SOURce]:ERMes:MESSage:ALPHanumeric[:SELect] "FOX" | "ALPHA" | "LONG" | "USER1" |
"USER2" | "USER3"
The command selects the alphanumeric message. The following is available:
"FOX" The quick brown fox jumps over the lazy dog
"ALPHA" ABCD to (complete ERMES character set)
"LONG" Message completely filling a batcht
"USER1to3" Three messages which can be edited freely using command
ALPHanumeric:DATA
Example: :SOUR:ERM:MESS:ALPH:SEL FOX *RST value is USER3
[:SOURce]:ERMes:MESSage:ALPHanumeric:DATA "String"
The command permits the input of an arbitrary character string into one of the alphanumeric
messages USER1 to 3. This message must be selected before using ALPHanumeric:SELect.
*RST value is "" (i.e., empty message)
Example: :SOUR:ERM:MESS:ALPH:DATA "Hello"
[:SOURce]:ERMes:MESSage:NUMeric "string"
The command specifies which character string the numeric message consists of. The SME
permits maximally 16 digits. In addition to the 10 digits "0" to "9", the signs forward slash "/",
upper-case letter "U", hyphen "-", period ".", percent "%" and blank can be used. This command
is only effective if CATegory NUMeric has been selected.
Example: :SOUR:ERM:MESS:NUM "12% 15-17" *RST value is "" (i.e., empty message)

Table of Contents

Related product manuals