SME SOURce:LIST
1038.6002.02 3.75 E-133
3.6.11.9 SOURce:LIST Subsystem
This subsystem contains the commands for the LIST operating mode of the RF generator. Processing
the lists is controlled by the TRIGger:LIST subsystem. Each list consists of a FREQuency, POWer
and DWELl content. The list contents must all be of the same length except for contents of length 1.
This is interpreted as if the content had the same length as the other contents and all values were equal
to the first value. After a list has been created and changed, command :LIST:LEARn has to be entered
to have the settings transferred to the hardware.
The LIST mode is activated by command SOURce:FREQuency:MODE LIST.
The LIST subsystem is not valid for SME03E economy model.
Note: SCPI designates the individual lists as segments.
Command Parameter Default
Unit
Remark
[:SOURce]
:LIST
:CATalog?
:DELete
:ALL
:DWELl
:POINts?
:FREE?
:FREQuency
:POINts?
:LEARn
:MODE
:POWer
:POINts?
:SELect
"Name of list"
1ms to1 s {,1 ms to 1 s}
5kHz to 1.5GHz {, 5kHz to 1.5GHz}|block data
AUTO | STEP
-144 to 16 dBm {, -144 to 16 dBm}|block data
"Name of list"
s
Hz
Query only
Query only
5kHz to 3/6
GHz(SME03/06)
Query only
No query
Query only
[:SOURce]:LIST:CATalog?
The command requests a list of the lists available separated by commas. The command is a
query and hence has no *RST value.
Example: :SOUR:LIST:CAT? Answer: "MYLIST", "LIST1", "LIST2"
[:SOURce]:LIST:DELete "Name of list"
The command deletes the list indicated. This list must not be selected.
*RST has no influence on data lists.
Example: :SOUR:LIST:DEL "LIST2"
[:SOURce]:LIST:DELete:ALL
The command deletes all lists. As a possibly selected list is deleted as well, the LIST mode must
be switched off (SOURce:FREQuency:MODE CW or SWEep). *RST has no influence on data lists.
Example: :SOUR:LIST:DEL:ALL
To Next Page
Loading...
