SME SOURce:LIST
1038.6002.02 3.77 E-133
[:SOURce]:LIST:MODE AUTO | STEP
The command indicates the mode in which the list is to be processed (by analogy with
SOURce:SWEep:MODE).
AUTOEach trigger event triggers a complete list run.
STEP Each trigger event triggers only one step in processing the list.
Example: :SOUR:LIST:MODE STEP *RST value is AUTO
[:SOURce]:LIST:POWer -144 to 16 dBm {, -144 to 16 dBm} | block data
The command fills the LEVel part of the RF list selected with data. The data can either be
indicated as a list of numbers (separated by commas) of arbitrary length or as binary block data.
As to the format of the data, cf. command :SOURce:LIST:FREQ. *RST does not influence data
lists.
Example: :SOUR:LIST:POW 0dBm, -2dBm, -2dBm, -3dBm,...
[:SOURce]:LIST:POWer:POINts?
The command queries the length (in items) of the LEVel part of the list presently selected. The
command is a query and thus has no *RST value
Example: :SOUR:LIST:POW:POIN? Answer: 32
[:SOURce]:LIST:SELect "Name of list"
The command selects the list indicated. If there is no list of this name, a new list is created. The
name may contain up to 7 letters. The command triggers an event and thus has no *RST value
Example: :SOUR:LIST:SEL "LIST1"
To Next Page
Loading...
