Rohde & Schwarz SME02 - Source:phase Subsystem

SME SOURce:PHASe
1038.6002.02 3.81 E-13
3.6.11.12 SOURce:PHASe Subsystem
Command Parameter Default
Unit
Remark
[:SOURce]
:PHASe
[:ADJust]
:REFerence
-360 deg to +360 deg rad
No query
[:SOURce]:PHASe[:ADJust] -360 deg to +360 deg
The command indicates the phase between output signal and reference oscillator signal. This
setting is only accepted using SOURce:PHASe:REFerence (cf. below). An indication in RADian
is possible.
Example: :SOUR:PHAS:ADJ 2DEG
:SOUR:PHAS:ADJ 0.1RAD *RST value is 0.0 DEG
[:SOURce]:PHASe:REFerence
The command accepts the phase set using SOURce:PHASe:ADJust as a new reference phase.
The command has no *RST value.
Example: :SOUR:PHAS:REF