SME SOURce:POCSag
1038.6002.02 3.85 E-13
[:SOURce]:POCSag:DEViation 1.5 | 2.0 | 3.0 | 3.5 | 4.0 | 4.5 kHz
The command enters the input value of the frequency deviation for the set modulation.
For FSK 4.0 kHz and 4.5 kHz are possible, for FFSK 1.5 kHz, 2.0 kHz, 3.0 kHz, 3.5 kHz, 4.0 kHz
and 4.5 kHz. The instrument stores two independent deviation values (one for each type of
modulation). The value which is displayed and used depends on the modulation setting.
Example: :SOUR:POCS:DEV 4.5kHz *RST value is 4kHz
[:SOURce]:POCSag:BRATe 512bps | 1200bps | 2400bps
The command selects the bitrate, at which the data should be outputted. Possible values are: 512,
1200, and 2400 baud.
Example: :SOUR:POCS:BRAT 512bps *RST value is 512bps
[:SOURce]:POCSag:ERRor:MASK 0 to 4294967295
The command determines the erroneous bits in a 32-bit field. The transmitted decimal number
(0...4294967295) is converted internally into a 32-bit binary number and thus defines the 32 bits.
These bits are XORed with the word of the message which is to be falsified and thus determine
which bits of this word are to be transmitted correctly or incorrectly.
Example:
:SOUR:POCS:ERRor:MASK 0 *RST value is 0.
[:SOURce]:POCSag:ERRor:WORD 0 to 16
The command determines the position of the word to be falsified in the batch. Value 0 denotes the
synchronization word.
Example: :SOUR:POCS:ERRor:WORD 0 *RST value is 0.
[:SOURce]:POCSag:LBATches 0 to 100
The command sets the number of filler batches which are transmitted before the message
(Leading BAT
ches). *RST value : 0
Example: :SOUR:POCS:LBAT 0
[:SOURce]:POCSag:MESSage
The parameters of this section are used for setting the destination address as well as the useful
data of the message.
[:SOURce]:POCSag:MESSage:ADDRess 0 to 2097151
The command sets the address of the pager to be called. The specified range is 0 to 2097151.
Example: :SOUR:POCS:MESS:ADDR 1 *RST value is 1
[:SOURce]:POCSag:MESSage:CATegory NUMeric | TONE | ALPHanumeric
The command selects the category of the transmitted message.
TONETone-only message
NUMeric Numeric message,
ALPHanumeric Alphanumeric message. *RST value is TONE
Example: :SOUR:POCS:MESS:CAT TONE
To Next Page
Loading...
