SOURce:POCSag SME
1038.6002.02 3.86 E-13
[:SOURce]:POCSag:MESSage:SWORd POCSag | INForuf
The command selects the contents of the sync word. This word distinguishes between the various
types of paging services.
POCSAG 0x7CD215D8; also used for CITYRUF
INFORUF 0x7CD21436. *RST value is POCSag
Example: :SOUR:POCS:MESS:SWOR POCS
[:SOURce]:POCSag:MESSage:TONE A | B | C | D
The command selects the tone which is transmitted during category TONE. Four tones are
available (A, B, C, D).
Note: Only true tone-only receivers can process all four possible values.
Numerical and alphanumerical receivers react to tone-only pages only when tone
number is B or C.
Example: :SOUR:POCS:MESS:TONE B *RST value is TONE
[:SOURce]:POCSag:MESSage:NUMeric "String"
The command determines the type of character string the numeric message may consist of. SME
allows a maximum of 41 characters. In addition to the 10 figures "0" to "9" other characters such
as square brackets right and left "[", "]", upper case letter "U", hyphen "-" and blank space " " can
be used.
Example: :SOUR:POCS:MESS:NUM "12-17" *RST value is 0123456789 U-[]
[:SOURce]:POCSag:MESSage:ALPHanumeric
This node contains commands for the determination of the contents of the alphanumeric
messages. There is one common character set for FLEX and POGSAG. These commands can
only be activated if POCS:MESSage:CATegory ALPHanumeric is selected.
[:SOURce]:POCSag:MESSage:ALPHanumeric[:SELect] "FOX" | "ALPHA" | "USER 1" | "USER2" |
"USER3" | "USER4"
The command selects the alphanumeric message. The following selection can be made:
"FOX" The quick brown fox jumps over the lazy dog
"ALPHA" ABCD to (complete POGSAG character set)
"USER1 to 4" 4 messages that can be freely edited by command ALPHanumeric:DATA.
Example: :SOUR:POCS:MESS:ALPH:SEL "FOX" *RST value is USER3
[:SOURce]:POCSag:MESSage:ALPHanumeric:CATalog?
The command queries the alphanumeric messages available. It causes a list to be returned on
which the entries are separated by commas. The command is a query command and thus has no
*RST value.
Example: :SOUR:POCS:MESS:ALPH:CAT? Answer: FOX, ALPHA, USER1
[:SOURce]:POCSag:MESSage:ALPHanumeric:DATA "String"
The command allows any character string to be entered into one of the alphanumeric messages
USER 1 to 4. This message has to be selected first with the command
ALPHanumeric:SELect. *RST value is "" (eg, empty message)
Example: :SOUR:POCS:MESS:ALPH:DATA "Hello"
To Next Page
Loading...
