SME SOURce:REFLex25
1038.6002.02 3.95 E-13
[:SOURce]:REFLex25:MESSage:ALPHanumeric[:SELect] “name“
This command selects the alphanumeric message. Valid values:
FOX Selection of an alphanumeric message.
ALPHA „ABCD...“ (complete ReFLEX25 character set)
USER1 to 4 4 messages that can be freely varied using command REFL25:MESS:ALPH:DATA
The parameter is not influenced by *RST.
Example: SOUR:REFL25:MESS:ALPH:SEL “FOX“
[:SOURce]:REFLex25:MESSage:ALPHanumeric:CATalog?
The command queries the alphanumeric messages. It causes a list to be returned on which the
entries are separated by commas. The list contains the values FOX, ALPHA, USER1, USER2,
USER3, USER4. This is a query, it features no *RST value.
Example: SOUR:REFL25:MESS:ALPH:CAT?
[:SOURce]:REFLex25:MESSage:ALPHanumeric:DATA “alphanumeric data string“
This command is used to fill the list selected using REFL25:MESS:ALPH:SEL with the transferred
data. The string may contain a maximum of 128 characters which must be part of the alphabet
defined in the ReFLEX25 documentation. ReFLEX25 and Flex share a common set of messages
- changing ReFLEX25 causes the message under Flex to be changed as well. The messages are
not influenced by *RST.
Example: SOUR:REFL25:MESS:ALPH:DATA “hello“
[:SOURce]:REFLex25:MESSage:NUMeric “numeric data string“
This command enters the character string for a numeric message. The „numeric data string“ may
contain a maximum of 41 characters. In addition to the 10 figures“0“ to “9“ other characters such
as square brackets left and right “[“ and “]“, upper-case letter “U“, hyphen “-“ and blank space “ “
can be used. The parameter is not influenced by *RST.
Example: SOUR:REFL25:MESS:NUM “[49-89-]1111-2222“
[:SOURce]:REFLex25:MESSage:RREQuired ON | OFF
This command determines whether the receiver is to confirm the message or not. The respective
bit is set in the message. In the case of OFF, the vector field is reduced by one code word if this is
permitted by the ReFLEX standard. *RST value is OFF
Example: SOUR:REFL25:MESS:RREQ ON
[:SOURce]:REFLex25:SI | SINFormation:ZONE 0 to 4091
This command sets the geographical transmit zone. The significance is specified by the network
operator. The value 0 is referred to as “restricted“ in the ReFLEX25 documentation, but can be set
for test purposes. The upper limit is 4091. *RST value is 1
Example: SOUR:REFL25:SI:ZONE 91
To Next Page
Loading...
