SME List of Commands
1038.6002.02 8C.1 E-12
Annex C
List of Commands (with SCPI Conformity Information
The SME supports SCPI version 1994.0. For remote control, commands which were specified or
accepted in this SCPI version have been used to a large extent. Commands which are not part of the
SCPI specification are marked "not-SCPI" in the SCPI info.
Structure and Syntax of messages are explained in Chapter 3.5, and a detailled description of
commands is to be found in Chapter 3.6.
Command
Parameter
SCPI
info
Page
:ABORt:DM not-SCPI 3.17
:ABORt:LIST not-SCPI 3.17
:ABORt:MSEQuence not-SCPI 3.17
:ABORt[:SWEep] not-SCPI 3.17
:ABORt:XMEM not-SCPI 3.17
:CALibration:LEVel:DATA? not-SCPI 3.19
:CALibration:LEVel:FRANge NORMal | MIXer not-SCPI 3.19
:CALibration:LEVel:PMODulator ON | OFF not-SCPI 3.19
:CALibration:LEVel:STATe ON | OFF not-SCPI 3.19
:CALibration:LPReset:DATA? not-SCPI 3.19
:CALibration:LPReset[:MEASure]? not-SCPI 3.19
:CALibration:PULSe:DATA? not-SCPI 3.20
:CALibration:PULSe[:MEASure]? not-SCPI 3.20
:CALibration:QPSK:STORe not-SCPI 3.18
:CALibration:QPSK[:DATA]
0 to 10 000 ns | DEFault
not-SCPI 3.18
:CALibration:ROSCillator[:DATA] 0 to 4095 not-SCPI 3.20
:CALibration:VSUMmation:DAC? not-SCPI 3.20
:CALibration:VSUMmation:KOS? not-SCPI 3.20
:CALibration:VSUMmation[:MEASure]? not-SCPI 3.20
:CALibration:VSUMmation:OFFS? not-SCPI 3.20
:DIAGnostic:INFO:CCOunt:ATTenuator 1 | 2 | 3 | 4 | 5 | 6? 3.21
:DIAGnostic:INFO:CCOunt:POWer? 3.22
To Next Page
Loading...
