List Editor SMIQ
1125.5555.03 E-82.34
CREATE NEW LIST
Generating a new list. The name of the list cannot be selected freely in the
case of manual control. A definite list name is automatically generated in the
following form:
MSEQ<n>, with <n> ∈ {0..9}, e.g. MSEQ1 (with Memory Sequence)
This applies correspondingly to the other operating modes. In the case of
level correction mode, UCOR1 would be generated for example. If a list is
created via IEC bus, an arbitrary list name can be given (cf. Section 3).
Unrestricted access is also possible by means of the selection window.
MSEQ2 100
The list currently set is marked in the selection window by means of the
selection mark, here MSEQ2. In addition to the list name, the length of the list
is given, here 100 elements.
2.2.12.2 Deletion of Lists - DELETE LIST
DELETE LIST opens a selection window in which the list to be deleted can be selected. The lists are
represented together with their name and their length (cf. Fig. 2-9). By pressing the [RETURN] key the
selection window is exited without deleting a list.
Delete list
Ø Mark desired list using the rotary knob.
Ø Press [SELECT] key.
The prompt "enter [SELECT] to delete list/sequence?" is displayed
Ø Press [SELECT] key.
The list is deleted. If the prompt is acknowledged with the [RETURN] key,
however, the list is not deleted. The selection window is automatically
closed due to the acknowledgment of the prompt.
Selection: DELETE LIST
LEVEL
- 30.0
100. 000 000 0
FREQ
MHz
dBm
MODE OFF AUTO SINGLE
RESET SEQUENCE
CURRENT INDEX
SELECT LIST...
DELETE LIST...
FUNCTION
MSEQ1 199
MSEQ2 100
MSEQ3 1
MSEQ4 123
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
Fig. 2-9 DELETE-LIST selection window
To Next Page
Loading...
