List Editor SMIQ
1125.5555.03 2.36 E-8
Select parameters
Ø Mark the index associated to the parameter using the rotary knob or directly
enter the value of the index via the numeric keys.
Ø Press [SELECT] key.
Parameter MEMORY is marked. If the second parameter DWELL is to be
marked, press the [SELECT] key again.
Modify parameters
Ø Vary the value of the parameter selected using the rotary knob or enter the
value directly using numeric keys.
Note: The binary data of the digital modulations which cannot be varied
are an exception. Further, all numeric keys except for "0" and "1" are
ineffective in these cases.
Ø Press the [ENTER] key or unit keys.
The value is included in the data set. The menu cursor marks the value of
the next column. In the last column, the menu cursor then marks the next
line of column MEMORY.
Ø Press the [RETURN] key.
The menu cursor wraps back to the INDEX column. The EDIT mode is
exited by repeatedly pressing the [RETURN] key (cf. Section 2.2.11.4).
Block function FILL
Using function FILL, a parameter, e.g. MEMORY, is overwritten with constant or linearly
increasing/decreasing values within a defined range. The input window is exited by pressing the
[RETURN] key without a modification being carried out.
If the filler range exceeds the end of the list, the list is automatically extended.
The list entry, in the example for MEMORY, with index [AT +n] is calculated as follows from the
information AT, RANGE, starting value (MEMORY) and WITH INCREMENT:
MEMORY[AT+n] = starting value (MEMORY)+ n · increment | (0 ≤ n ≤ RANGE1)
Selection: FUNCTION-FILL
FREQ
100. 000 000 0
MHz
LEVEL
- 30.0
dBm
SELECT LIST...
FUNCTION
-INDEX - FREE 246 - LEN 10
0001
0002
0003
0004
0005
0006
0007
0008
FILL AT
10 RANGE 1
PARAMETER MEMORY DWELL
MEMORY 1
WITH INCREMENT 0
EXECUTE
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
Fig. 2-11 Block function FILL: Input window
To Next Page
Loading...
