SMIQ Introduction on how to use the manual
1125.5610.12 E-7R.3
Chapter 3 provides information on remote control of SMIQ. It informs about basics like
IEC/IEEE bus, RS-232C interface, interface and device-dependent messages,
command processing, status reporting system etc. It also includes an
overview of each command system and describes all commands available in
the unit and its options.
Chapter 4 informs about preventive maintenance and functional tests.
Chapter 5 contains information on how to check the rated specifications (required test
equipment, test setup, test procedure) and on the performance test report.
Annex A provides information on interfaces.
Annex B contains a list of SCPI- and SMIQ-specific error messages displayed by the
unit.
Annex C provides an alphabetical list of commands.
Annex D gives programming examples for remote control.
Index provides the index with entries in alphabetical order.
To Next Page
Loading...
