SMIQ Digital Standard PHS
1125.5555.03 E-92.125
SLOT ATTENUATION
Input value for the level reduction in dB of all active slots whose SLOT LEVEL
was set to ATTEN. Menu SELECT SLOT allows the slots to be determined
whose level is to be reduced.
IEC/IEEE-bus command
:SOUR:PHS:SLOT:ATT 40 DB
SAVE/RCL FRAME...
Opens a window for saving and loading a frame configuration. Loading a
frame affects all parameters that can be set under SELECT SLOT.
FREQ
100. 000 000 0
MHz
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
PHS
PHS
IS95
NADC
PDC
GSM
TRIGGER MODE
EXECUTE TRIG
TRIGGER....
CLOCK...
POWER RAMP C>
SLOT ATTENUA
SAVE/RCL FRA
GET PREDEFINED FRAME
...
RECALL FRAME...
SAVE FRAME...
DELETE FRAME...
LEVEL
-30.0
dBm
PEP
-27.5
dBm
SYNC
DN
12
Fig. 2-74 Menu DIGITAL STD - PHS - SAVE/RCL FRAME, SMIQ equipped with Modulation Coder
SMIQB20 and Data Generator SMIQB11
(SAVE/RCL FRAME...) GET PREDEFINED
FRAME...
Loads a factory-set frame configuration.
DN1_TCH Downlink Traffic Channel in slot1
UP1_TCH Uplink Traffic Channel in slot1
DN1_SYNC Downlink Sync Channel in slot1
IEEE
:SOUR:PHS:FLIS:PRED:LOAD "DN1_TCH"
RECALL FRAME...
Loads a frame configuration saved by the user.
IEC/IEEE-bus
:SOUR:PHS:FLIS:LOAD "name"
SAVE FRAME...
Saves a user-defined frame configuration.
IEC/IEEE-bus
:SOUR:PHS:FLIS:STOR "name"
DELETE FRAME...
Deletes a frame configuration saved by the user.
IEC/IEEE-bus
:SOUR:PHS:FLIS:DEL "name"
To Next Page
Loading...
